035-6952399
info@broditstore.nl

Brodit houder/lader Zebra TC15 fixed install.-fits with boot

Sale
Brodit houder/lader Zebra TC15 fixed install.-fits with boot
  • €104,91 €118,96
  • Excl. BTW: €86,70
  • Beschikbaarheid:Niet op voorraad
  • SKU: 713355
Active holder for fixed installation

With tilt swivel. 2,7A charging. 12/24V. With Easy-switching system. Charging via pogo pins. Fits device with Zebra Original Rugged Boot.

An active holder which is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior! You can choose to use the holder as an active holder for charging of your device only, or to connect an adapter to the Molex connector for additional features. Then you can use the holder also for power supply of a GPS receiver or other own solutions (can not be used for data communication or audio connection). 12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2,7A charger.  Professional installation recommended.

 

Easy-switching system:

The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.

Instructies

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.
3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel and screw it into place. Tighten the screw so the holder is firmly in place, but still can be adjusted.
4. The holder is in place.
Meer informatie
Accessoiremerk Brodit
Afsluitbaar nee
Barcode 7320287133554
Easy switching system Ja, met het easy-switching-systeem hoeft u alleen de houder te vervangen, de geïnstalleerde kabels blijven behouden. Het bespaart tijd! Je koppelt de houder los via de Molex 6-polige snelkoppeling en de nieuwe houder weer aan, omschakeling in seconden!
Houder uitvoering Vaste installatie
Kleur.. Zwart
Productinfo Professionele houder met swivel (17° kantel- en 360° draaibare adapter).
Prof. houder kenmerk passend voor toestel zonder orginele boot, Opladen via pogo-pinnen
Toestel houder kenmerk Toestelspecifiek
Toestel houdertype PDA houder
Voltage 12/24V geschikt
Toestel merk Model
Zebra TC15